Your bezel is polished green ceramic. So is your dial. Not lacquer, not paint — the same material, the same finish, the same colour, running from the outer edge of the watch all the way to the centre.
That makes this the most single-minded Seamaster Omega currently sells, and it reduces the strap decision to one question: do you extend the green, or break it?
Both are right. They just produce very different watches.
The fit: 20mm
The 210.30.42.20.10.001 is the 42mm Diver 300M case — 49.93mm lug-to-lug, 13.6mm thick — and the distance between the lugs is 20mm.
Every strap in our Diver 300M collection comes in 20mm and 22mm, so select 20mm. Buckle colour: silver, matching the brushed and polished steel case.
Straps are cut 120mm + 85mm and spring bars are included. The Omega strap installation tool makes the swap quick.
One thing worth knowing before you feel precious about it: Omega sells this exact watch on rubber. Reference 210.32.42.20.10.001 is the identical green Diver 300M — same case, same ceramic dial, same calibre — presented on a green rubber strap instead of the bracelet. Changing yours is not a modification. It is the other half of the reference.
What you own
A 42mm steel case, water resistant to 300 metres, with a conical helium escape valve and a domed sapphire crystal anti-reflective on both sides.
The bezel is green ceramic with a white enamel diving scale, unidirectional. The dial is polished green zirconium oxide ceramic — you will find "[ZrO2]" engraved on it, just below the centre hands — with laser-engraved waves across the whole surface and a date window at 6. The skeleton hands and raised indexes are rhodium-plated and filled with white Super-LumiNova.
Inside is the Master Chronometer calibre 8800, 35 jewels, 25,200 vph, around 55 hours of reserve, with a silicon balance spring and resistance beyond 15,000 gauss, visible through the wave-edged sapphire caseback.
On the bracelet, the whole thing weighs about 198 grams.
Why the bracelet comes off
Two practical reasons and one aesthetic one.
198 grams is substantial. It is a well-made bracelet with a comfort setting and a diver extension, and it is also most of the weight of the watch. Rubber takes a large part of that off without changing how the watch reads from above.
It is a 300-metre dive watch. Salt water gets into every link and every pin, and getting it out again means rinsing and drying the whole bracelet properly, every time. Rubber goes under a tap.
And the bracelet is the only brushed thing on a very glossy watch. Polished ceramic bezel, polished ceramic dial, polished-and-brushed case — then a mostly brushed steel bracelet. It is not a mismatch exactly, but it is the one part of the watch that isn't playing the same game.
Four that work
1. Green — extend it
Start here, because Omega did. The factory rubber version of this reference wears green, and the logic is sound: on a watch where the bezel and the dial are already the same colour, a green strap carries that colour past the lugs and turns the whole thing into one continuous object.
The effect is more striking than a green dial on its own. It is also the only watch we sell a green strap for where green is the entire point rather than an accent — everything else in the range treats green as a highlight. Green rubber strap →
2. Black — break it
The opposite discipline, and the more wearable of the two. Black rubber stops the green at the lugs, which means the dial and bezel become the only colour anywhere in the picture and read more intensely for it.
This is the version that looks like a serious dive watch rather than a green watch. It is also the collection's best seller and the one that will go with everything you own. Black rubber strap →
3. White — answer the enamel
Look at what is not green on this watch: the white enamel diving scale on the bezel, and the white Super-LumiNova in the indexes and hands. That is the entire secondary palette, and a white strap picks up both.
Against polished green it is high contrast without being loud, and it makes the watch look considerably lighter and more summery than either of the options above. The best-looking of the four in bright sun. White rubber strap →
4. Orange — the diver's contrast
The bold one, and not arbitrary. Orange sits opposite green, which is why it looks deliberate rather than clashing, and orange has been dive-watch shorthand for visibility for as long as there have been dive watches.
On a glossy green ceramic dial it is the loudest thing you can do, and it is the pick that makes people ask about the watch. Weekend strap. Orange rubber strap →
Not on the list: navy. It is an excellent strap on the blue and black Diver 300Ms, but blue and green sit too close together to read as a decision — the watch ends up looking like it is trying to be two colours at once.
Related Omega guides
- Omega Seamaster Diver 300M strap guide — the whole 42mm generation, including the black and blue dials
- All Omega strap guides
Ready to change it?
Helvetus is one of the largest names in aftermarket luxury watch straps, and our Omega straps are cut to specific cases rather than trimmed from a universal blank — so a 20mm strap sits flush at the lugs instead of leaving a gap.
All rubber straps carry a lifetime warranty. Shipping is free worldwide, there are no import costs wherever you order from, and more than 50,000 customers have already made the swap.
Browse all Diver 300M straps → See the full Omega strap range →
Helvetus is not affiliated with Omega SA. Model names are used for compatibility reference only.











